The samples were then annealed at 400°C for 1 h in air atmosphere. The morphology of the sample was studied by scanning electron microscopy (FE-SEM; JEOL JSM-6700F, Akishima-shi, Japan). The structure and crystallinity of the samples were investigated by X-ray diffraction (XRD; D8, Bruker AXS, Inc., Madison, WI, USA). The optical properties of the samples were characterized by ultraviolet–visible (UV–vis)-IR absorption (UV360 spectrometer, Shimadzu, Corporation, Kyoto, Japan). The microstructure of a single nanorod was observed by transmission electron microscopy (TEM; FEI TECNAI G20, Hillsboro, OR, USA). Photoelectrochemical measurements were performed in a sulfide/polysulfide (S2−/Sn2−)

electrolyte containing 0.5 M S and 0.3 M Na2S dissolved Capmatinib in deionized water, in which the TiO2/CdS arrays on FTO, Pt foil, and SCE were used as the working, counter, and reference electrodes, respectively. The illumination source used was AM1.5G light at 100 mW/cm2. Results and discussion Figure 1 shows the SEM images of the TiO2 NRAs and

the TiO2/CdS core-shell structure. The TiO2 NRAs are vertically Selleck Geneticin aligned on the FTO, with an average diameter of 80 to 100 nm, as shown in Figure 1a. The TiO2 VE-822 chemical structure nanorods are dense and compactly arranged in the same direction. The top facets of the nanorods appear rough, and the side facets are smooth. In addition, the nanorods show a uniform length. The TiO2 NRAs are grown perpendicularly to the FTO substrate, with lengths of about 3 μm, which is helpful for QD sensitization, Pregnenolone as shown in Figure 1b. CdS QDs are deposited on the TiO2 NRAs (denoted as FTO/TiO2/CdS) by SILAR. After

the deposition of CdS QDs, the entire surface of the TiO2 NRAs was uniformly covered with dense CdS QDs. Moreover, the cycle times of CdS QDs increased (Figure 1c,d,e,f), the surface of TiO2 NRAs gradually became rough, and the diameter of TiO2/CdS was thicker. The diameters of the TiO2/CdS core-shell structure with 10, 30, and 70 cycles were approximately 90 to 110 nm, 125 to 150 nm, and 150 to 175 nm, respectively. The gap between the TiO2 nanorods became smaller. Figure 1 SEM images of TiO 2 nanorod arrays and TiO 2 /CdS core-shell structure with different cycles. (a) Top view of bare TiO2 nanorod arrays. (b) Cross-sectional view of bare well-aligned TiO2 nanorod arrays. Top view of the TiO2/CdS core-shell structure with (c) 10, (d) 30, (e) 70, and (f) 80 SILAR cycles. Figure 2 shows the XRD patterns of the TiO2 NRAs (blue curve) and the TiO2/CdS core-shell structure (red curve). The XRD pattern showed that the TiO2 samples have a tetragonal rutile structure and the FTO substrates have a rutile structure (JCPDS no. 41-1445). Three peaks appeared at 36.2°, 62.9°, and 70.0°, which are respectively indexed to the (101), (002), and (112) planes of the TiO2 (JCPDS no. 89-4920). The enhanced (002) peak located at 62.