6 mm with 5 μ particle size, Phenomenax) using a mobile phase combination of 0.1% ortho phosphoric acid aqueous solution and acetonitrile (45:55, v/v) in an isocratic

mode elution with a flow rate of 1.2 mL min−1 at the column oven temperature of 35 °C. The detection was monitored at a wavelength of 262 nm. Fig. 1 shows a typical chromatogram of curcumin and piperine indicating complete resolution of curcumin at 8.685 min and piperine at 5.969 min. Six replicate injections containing curcumin (150 μg mL−1) and piperine (150 μg mL−1) and the results are summarized in Table 1. The developed method satisfies the acceptance criteria of the system suitability parameters and ensures the validity of the developed method. Three replicate injections containing click here known amount of curcumin and piperine at 50%, 100% and 150% were added to the pre-analysed samples (150 μg mL−1 http://www.selleckchem.com/products/Y-27632.html of curcumin and 150 μg mL−1 of piperine) and analysed using the developed method. The results are summarized in Table 2. The developed method satisfies the acceptance criteria of the recovery study

and ensure accuracy of the developed method. Six replicate injections containing curcumin (150 μg mL−1) and piperine (150 μg mL−1) and the results Phosphatidylinositol diacylglycerol-lyase are summarized in Table 3. The % R.S.D of the assay, peak area and tailing were less than 1% which denoted very good repeatability of the measurement. Hence the developed method displayed a good precision. The LOD were 0.3 ppm for curcumin and 0.1 ppm for piperine at a signal-to-noise ratio of 3:1. Similarly, LOQ were 0.4 ppm for curcumin and 0.9 ppm for piperine at a signal-to-noise ratio of 10:1. Calibration standard solutions of 10, 25, 50, 100 and 150 μg mL−1 were prepared and analysed using the developed

method. Obtained peak areas were plotted Libraries against the concentration and the linearity was calculated by least square regression method. The results are summarized in Table 4. The robustness of the developed method was investigated with slight change in the column oven temperature (30 °C & 40 °C) and pH of the mobile phase (2.8–3.2) and the results are summarized in Table 5. However, these changes had an influence on the assay but not considered significant as the % R.S.D was ≤2%. The developed method was successfully implemented to determine the encapsulation efficiency of curcumin and piperine in the Eudragit E 100 nanoparticles. The results are summarized in Table 6. Both methods have shown lesser standard deviation and % R.S.D was less than 2% which ensures the precision of the developed method.